Aleratec 1:3 DVD/CD Auto Publisher LS Guia De Inicio Rapido página 4

Hardware Installation
Procedure Overview
1. Verify PC is off
2. Connect Cables
3. Turn on PC
4. Insert Install CD
5. Turn on Duplicator
6. Install Drivers
7. Install Ink Cartridges
8. Install Software
Connect the Cables and Apply Power
Plug the USB 2.0 Cable into the USB connector located on the center
rear of the 1:3 DVD/CD Auto Publisher LS unit. Connect the other
end of the USB cable into an available USB 2.0 port on your PC.
Plug the power cord into the power supply of the 1:3 DVD/CD Auto
Publisher LS, also located on the rear side (make sure the red switch
is set at 115 VAC). Plug into a standard 115 VAC outlet. Use of a
common plug strip with AC filtering, as is common with most high-
end computers, is recommended for the 1:3 DVD/CD Auto Publisher
LS.
Note: Use only with a USB 2.0 port. This system cannot be used with USB
1.1, as this will greatly affect system performance. If Windows displays a
message that a fast USB device is detected on a slow USB port, then you
will need to upgrade your computer by adding a USB 2.0 port.
2 www.aleratec.com