Krups XP3200 Manual De Instrucciones página 17

IFU_KR_COFFEE_MAKER_XP3200_ 8000828507-01_Mise en page 1 13/09/10 16:38 Page1
English
Problems
The water tank
leaks when it
is carried.
Water leaks
under the
machine.
The pump is
unusually
noisy.
The cups are
not filled
equally.
Leaking filter
holder.
18
Possible causes
The valve at the
bottom of the tank
is dirty or defective.
The valve is blocked
by lime scale.
Internal leak.
Drip tray is not in
the correct position.
Drip tray has
overflowed.
No water in the
tank.
The tank is not
properly positioned.
The filter holder is
clogged.
Leaking filter holder.
The filter holder is
not properly
positioned.
The edges of the
filter holder are
clogged with excess
ground coffee.
Pod improperly
positioned in the
filter.
Solutions
Wash the water tank and push on
the valve at the bottom of the tank
to make sure it is not stuck.
Descale the machine
(see Section 8).
Check the position of the tank. If
the fault persists, do not use the
machine, contact an approved
service centre.
Check that the drip tray is pushed
completely into the machine (see
section 7).
Carefully empty and rinse the drip
tray, then replace in the machine
(see Section 7).
Stop the machine. Fill the water
tank, replace in the correct position,
and turn the machine back on.
Replace the tank in the correct
position.
Clean the filter holder
(see section 7).
Lock the filter holder firmly in place.
Take care when filling the filter to
brush excess coffee off the edges
before locking the filter holder in
place.
Check that the pod is properly
centered in the filter, with excess
paper removed from E.S.E. pods,
and that none of the paper is
hanging over the edges of the filter.