Operating The Shredder; If Something Does Not Work - Olympia PS 53 CC Manual De Instrucciones

Operating the Shredder

The shredder works using an automatic shredding mechanism� The insertion slot is provided
with a pivoting guard for your safety� The optical sensor for the material in the automatic insertion
is positioned in the centre of the slot�
c
aution
take hold of the shredder by the underside when the shredder is in operation�
1
Set the switch to its a
control lamp lights up�
2
Pivot the guard upwards�
W
arning
when material is inserted� Keep all loose pieces of clothing, jewellery, long hair or
other loose items away from the shredder's insertion slot�
3
Feed the material to be shred in the centre of the insertion slot� The insertion slot draws
the material in and stops 2 - 4 seconds after shredding has been completed and no further
material is fed in�
4
If you want to shred a credit card, insert the credit card in the centre of the slot with a short
edge to the front�
Switching the Shredder Off
Switch the shredder off when you no longer need to use it� This saves electricity and prevents
third parties inadvertently injuring themselves with the shredder�
1
Set the switch to its o
2
Pivot the guard downwards�
3
Disconnect the power plug from the power socket�

If Something Does Not Work

The following information should help if something does not work as you expect it to�
Overheating Protection
The motor switches off automatically in the event of overheating and overloading�
The POWER control lamp continues to light up blue� When the cool down phase has elapsed,
the shredder is ready to operate again� Pay attention to the intermittent operation value�
! Risk of injury through sharp edges on the cutting mechanism� NEVER
uto position� The shredder is now ready to operate� The blue POWER
! Risk of injury through automatic insertion� The infeed starts automatically
a
ttention ! Risk of property damage through material jam! Observe the
maximum cutting output of the insertion slot�
ff position�
13