Connecting The Camera - flir LOREX LZV2622 Serie Manual De Instrucciones

3

Connecting the Camera

• It is recommended to connect the camera to your DVR and test the PTZ controls before
permanent installation. For instructions on how to setup PTZ controls, see 5 Controlling
the PTZ Camera with your MPX DVR.
• When you first power up the camera and connect it to the DVR, it may take up to 2 mi-
nutes for the camera image to appear.
1. Connect the BNC video connector on the camera cable to the included ex-
tension cable.
2. Connect the female 12V DC power connector on the camera cable to the
male power connector on the included extension cable.
3. Connect the BNC cable on the extension cable to one of the Video Input
ports on the DVR. Make note of the port number where you connect the
camera, as it will be used when configuring the DVR to communicate with
the camera.
4. Connect the power connector on the extension cable to the included
power adapter. Plug the power adapter into a power outlet.
•
RS-485 is for service purposes only — not required for controlling MPX PTZ cameras.
#LX400075; r.38010/38010; en-US
NOTE
CAUTION
Make sure to disconnect the power adapter before installing the camera. The cam-
era will begin moving immediately when the power adapter is connected.
NOTE
4