Ice Making - Sharp SJ-FS810V Manual De Manejo

Preparations for the first-time

ice making

• Wash the water tank and the ice storage box.
• Carry out the Ice tray cleaning mode to clean the ice tray and
the pipe.
(There may be odor or dirt within the automatic ice maker.)
Ice making
WARNING
Use potable water only.
To start operation
At first, all the ice making mode are set "OFF".
1
Select one of the four modes.
Normal ice
Large ice
Flashing
2
Select "ON".
3
Finalize the setting.
4
Pull out the water tank and pour water
into it.
● Do not tilt the water tank
when carrying as the water
may spill.
Tank is full at this
position.
5
Set the water tank.
● Securely insert the water tank. Ice
cubes will not be made unless the
tank is inserted fully.
Ice is made automatically.
NOTE
• It takes about 24 hours to make the first set of ice cubes.
• For hygienic reasons, replace the water once a week even when
there is water remaining in the tank.
• When you leave the tank empty it may sometimes make a
groaning noise but this is normal.
Clear ice (normal size)
+
+
Clear ice (large size)
Ice making process indication
Ice cube process indication will change according to the
completion of the ice making as follows.
Indication
• Automatic ice making is not operating.
• Within 5 minutes after the water supply.
Ice making is started.
• About two-thirds of the ice making is
complete.
• When the ice storage box is full.
Ice making is finished. The ice cubes are
dropped to the ice storage box.
(Control panel will light up to show the
completion.)
Water tank is out of water. Pour water into
the water tank.
• Even if the water tank is empty, the
flashing will be turned off by opening and
closing the refrigerator doors. However, the
(Flashing)
flashing will restart after a short time.
NOTE
• Do not use other than potable water. Do not use hot water (heat-
resistance:60°C), juice, tea, soda and sports drink etc.(Dirtying of
interior may result.) Malfunction of the ice maker may occur as a
result.
• Large size ice may not be made when the water level of the water
tank is low even if large ice mode is selected.
• Do not place the shovel or food on top of the ice cubes. This may
cause the automatic ice maker to malfunction (damage of the
detection lever, etc.) or the case not being able to be pulled out.
Set the shovel at the designated location.
Protrusions of ice cubes
• There are some slits placed in the
ice tray. Therefore, the ice cubes
coming from the tray will have
protrusions from these slits.
• The protrusions may be pointed.
Be careful when putting the ice
cube directly in your mouth.
White in ice cubes and floating substance
• The minerals contained in water may solidify and whiten as
water freezes. Minerals turn into a state which is insoluble in
water once it freezes, so melting the ice cubes will leave only
white floating substances, but this is normal.
• This is more likely to happen when you use hard water
(e.g.The hardness of the water is 100mg/L or more).
• The same thing will happen even if clear ice is set "ON".
Condition
Detection lever
Slit
Ice tray
Protrusion
15