Tips For Saving Energy - Sharp SJ-FS810V Manual De Manejo

Energy Saving
Use this feature when you want to switch the appliance to
energy-saving operation.
To start operation
1
Select "Energy saving" icon.
(The icon is green.)
2
Select "ON".
3
Finalize the setting.
Additionally the handle indicator (Green) will blink
3 times.
Handle indicator in operation
• Every time you close the door, the indicator will flash (Green).
• If Plasmacluster is also in operation, the indicator will flash 6
times.
(Blue→Green→Blue→Green→Blue→Green)
To cancel operation
It is the same method as starting operation.
Select "OFF" in step 2.
NOTE
• While this feature is operating, the inside temperature of the
refrigerator and freezer compartment will be higher than the preset
temperature by about 1°C(refrigerator) and about 2°C(freezer).
This is the guide under the condition of the preset temperature
3°C(refrigerator) and -18°C(freezer). The display of preset
temperature will not be changed.
• The efficiency of power saving depends on the usage environment
(controlling temperature, ambient temperature, frequency of
opening or closing the door, amount of food).
• Cancel this feature when you feel the beverages are not cooled
enough or ice making takes time.
Flashing

Tips for saving energy

■ Keep the ventilation space as much as possible around
the refrigerator.
■ Keep your refrigerator out of direct sunlight, and do not
place next to heat generating appliance.
■ Open your refrigerator door as briefly as possible.
■ Hot foods should be cooled before storing.
■ Place the food evenly on the shelves to allow the cooling
air to circulate efficiently.
The amount of power consumption of this model is
measured according to the international standard
of the refrigerator performance under the following
conditions.
• All accessories in the freezer
compartment are taken out as
indicated on the figure.
• Space dimensions.
90mm
300mm
60mm
300mm
9