Publicidad
3.
Drill pilot holes using a 7/32 in. (5.5 mm) diameter drill bit. Remove wall plate template
IMPORTANT: Be sure to drill into the center of the stud.
IMPORTANT: Pilot holes must be drilled to a depth of 3½ in. (89 mm).
4.
Install wall plate assembly using four lag bolts
CAUTION:
Avoid potential personal injury or property damage! All lag bolts MUST BE firmly tightened to prevent unwanted movement
of the wall plate assembly. Ensure the wall plate is securely fastened to the wall before continuing on to the next step.
Go to STEP 3 on PAGE 16.
3
. Tighten the lag bolts
14
3 ½ in. (89 mm)
11
7/32 in.
(5.5 mm)
.
11
only until they are pulled firmly against the wall plate assembly .
14
4
14
13
Publicidad
