Troubleshooting - Klarstein 10030106 Manual Del Usario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Defrosting of the freezer
The freezer compartment, however, will become progressively covered with frost. This should be removed.
Never use sharp metal tools to scrape off frost from the evaporator as you could damage it. However, when the
ice becomes very thick on the inner liner, complete defrosting should be carried out as fellows:
1. Pull out the plug from the socket;
2. Remove all stored food, wrap it in several layers of newspaper and put it in a cool place;
3. Keep the door open, and placing a basin underneath of the appliance to collect the defrost water;
4. When defrosting is completed, dry the interior thoroughly
5. Replace the plug in the power socket to run the appliance again.
Problem
Appliance does not
work.
The food is too warm.
Appliance cools too
much.
Unusual noises.
Water on the floor.

Troubleshooting

Possible Cause
Temperature regulation knob is set
at number "0".
Mains plug is not plugged in or is
loose.
Fuse has blown or is defective.
Socket is defective.
Temperature is not properly
adjusted.
Door was open for an extended
period.
A large quantity of warm food was
placed in the appliance within the
last 24 hours.
The appliance is near a heat
source.
Temperature is set too cold.
Appliance is not level.
The appliance is touching the wall
or other objects.
A component, e.g. a pipe, on the
rear of the appliance is touching
another part of the appliance or
the wall.
Water drain hole is blocked.
Solution
Set the knob at other number to switch on
the appliance.
Insert mains plug.
Check fuse, replace if necessary.
Mains malfunctions are to be corrected by an
electrician.
Please look in the initial Temperature Setting
section.
Open the door only as long as necessary.
Turn the temperature regulation to a colder
setting temporarily.
Please look in the installation location section.
Turn the temperature regulation knob to a
warmer setting temporarily.
Re-adjust the feet.
Move the appliance slightly.
If necessary, carefully bend the component
out of the way.
See the Cleaning and Care section.
26

Publicidad

Tabla de contenido
loading

Tabla de contenido