Emerson InSinkErator C1300 Manual De Instalación, Cuidado Y Uso página 3

2
InSTALLInG THE FAUCET - C1300
a
Property Damage: do not pinch or break copper
tubing. do not distort the last 1 inch of tubing.
b
Make sure to use rubber O-ring
to ensure proper seal.
c
An assistant may be needed
to hold the faucet in place
while securing the dispenser.
d
Semi-circular mounting plate should
encircle all descending tubes and
extend beyond sink hole when tight.
4
C1300
Unpack dispenser components.
On a firm, flat surface, carefully
straighten the copper tubing.
C1300
Ensure that the black O-ring is
properly seated in the base of the
faucet (the groove on the underside
of the faucet base).
C1300
Feed tubes down through the hole
in the sink or countertop until the
base is at rest on the sink or
countertop surface.
C1300
From under the sink, place the
1
2
semi-circular mounting plate onto the
threaded stud.
Place hex nut onto the threaded stud.
Ensure faucet is at desired angle.
Insert screwdriver into hole on side of
hex tool (creating a "T"), and use tool
to tighten nut and secure faucet.
3
2
InSTALLInG THE FAUCET - H778
a
Property Damage: do not pinch or break copper
tubing. do not distort the last 1 inch of tubing.
b
1 2
Fiber
Gasket
Make sure to use fiber gasket
to ensure proper seal.
3
Brass Nut
c
Ferrule
Gasket
An assistant may be needed
to hold the faucet in place
while securing the dispenser.
d
An assistant may be needed to hold the faucet
in place while securing the dispenser.
Do not over tighten the mounting screw
during installation, it may damage the faucet.
H778
Unpack dispenser components.
On a firm, flat surface, carefully
straighten the copper tubing.
1 2
H778
Ensure that the fiber gasket is
properly seated against the base
of the faucet.
3
Brass Nut
H778 Ferrule
Brass Insert
1
2
Feed tubes down the hole in the sink
1/4"
copper tube or countertop until the base is at rest
on the sink or countertop surface.
Position faucet at the desired angle.
3
1
2
H778
From under the sink, place the
semi-circular metal mounting plate
onto the threaded stud.
Place wing nut onto the threaded
stud. Make sure faucet head is at
the desired angle. Tighten the wing
nut until snug, while ensuring the
semi-circular mounting plate extends
3
beyond the sink hole.
For Technical Assistance
1-800-845-8345
1 2
3
5