Porter Cable RT-7690 Serie Guía Para El Usuario página 10

2. Turn on the level and/or plumb laser
and make desired selections from
the key pad. (See the Operating
Modes section.) As soon as one or
both of the lasers are turned on, the
displayed icons confirm the
selected laser(s) (level, plumb, or
both) and mode (Spin or Line
Dither/Scan). The level and plumb
lasers start up in Spin mode, at the
slowest speed.
Note: The LCD display shows the
!
laser modes for commands transmit
ted to the base unit from the RF
remote control. Commands made
from the base unit controls are not
shown on the RF remote control/
laser detector LCD display.
Press the Line Dither/Scan button
again to change to Line Dither/Scan mode.
X
Level laser, Line Dither/Scan mode,
Detector off
3. To turn on the laser detector, press the Coarse/Fine Select button
startup, the laser detector resolution is coarse,
indicated by the icons on LCD display. Continue pressing the Coarse/Fine
Select
X
Beeper on, Laser detector on, Coarse resolution,
Level laser, Spin mode
X
Beeper on, Laser detector on, Fine resolution,
Level laser, Spin mode
button to cycle through the following options:
Plumb laser, Spin mode,
X
Level laser, Spin mode,
Plumb laser, Line Dither/Scan mode,
X
Beeper off, Laser detector on, Coarse resolution,
Level laser, Spin mode
X
Beeper off, Laser detector on, Fine resolution,
Level laser, Spin mode
8
Y
Detector off
Detector off
Y
Detector off
with the beeper on
. On