User Safety; Warning Labels; Fcc Statement; Important - Porter Cable RT-7690 Serie Guía Para El Usuario

User Safety

The RT-7690 series self-leveling, remote-controlled, simultaneous level and plumb
rotational laser systems are Class IIIA laser products. Observe the following pre-
cautions when using the RT-7690 series laser systems:
• Always operate the unit according to the procedures in this user guide.
• Avoid direct eye exposure to the laser beam.
• Do not point the laser beam at your face, or another person's face.
• Turn off power to the base unit before moving it, to avoid accidental laser
exposure and to protect and lock the pendulum.
• Do not disassemble or attempt to service the unit (with the exception of cali-
bration, as described in the Calibration section).
Repairs or service are to be performed only by an authorized service center.

Warning Labels

The following labels are attached to every series RT-7690 units. They should not
be removed or defaced.
L A S E R R A D I AT I O N
AVOID DIRECT EYE EXPOSURE
635 nm 5mW max.
CLASS IIIA Laser Product

FCC Statement

This product has been tested and found to comply with the limits for a Class B dig-
ital device, pursuant to Part 15 of the FCC rules. These limits are designed to pro-
vide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interfer-
ence will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning
the equipment off and on, try to correct the interference by performing one or more
:
of the following
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC rules. Operation is subject to the fol-
lowing conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference
that may cause undesired operation.
IMPORTANT: Changes or modifications to this product not authorized by
Toolz could void the FCC Certification and negate your right to operate the
product.
This label is located on the front of the unit. It identifies the series RT-
7690 laser system as a device that emits laser radiation and requires
appropriate user safety precautions.
This label is shown next to every laser aperture on the product. It indi-
cates laser radiation is emitted from the level and plumb apertures.
This label indicates the RT-7690 series laser systems are certified and
approved for sale in Europe.
This label indicates the RT-7690 series laser systems are certified and
approved for sale in Australia.
2