Reflective Target; Laser Enhancement Glasses - Porter Cable RT-7690 Serie Guía Para El Usuario

X
4. Locate the laser beam, using the red sensor panel on the RF remote
control/laser detector. As the laser beam is approached, a single arrow
points in the direction of the beam. The base unit emits sounds to aid in
locating the laser beam:
• Rapid beep - Indicates that the laser detector is pointed overly high or
far to the left or right.
• Continuous tone - Indicates that the laser detector is pointed directly
toward the laser beam.
• Slow beep - Indicates that the laser detector is pointed overly low, or
off center in the opposite direction.
5. Center the beam by moving the laser
detector in the direction of the arrow.
When the beam is aligned with the
center of the detector panel, both
arrows on the LCD display are lit
and the beep is continuous, indicating
that it is properly centred.
Note: Laser detector orientation depends on
!
whether it is being used to locate the level or
plumb laser beam.
6. To turn off the RF remote control/laser detector,
press its Power On/Off button
double beep for confirmation, the LCD display
becomes blank, and the lasers shut off.

Reflective Target

The red acrylic used in the targets enhances the laser
beam, making the laser dot more visible.

Laser Enhancement Glasses

The red plastic used in the glasses enhances the laser beam, making the laser dot
more visible. These glasses are particularly useful when using the RT-7690 series
laser systems outdoors or in brightly lit environments.
Laser detector power off, Level laser,
Spin mode, Level laser, Spin mode
Level laser detection
. There is a
Plumb laser detection
9