Shoe Plate Sizes; Tools Required For Changing Shoe; Plates; Changing Shoe Plates - Campbell Hausfeld CHN50300 Instrucciones Para El Manejo

Operating Instructions and Parts Manual
Assembly (Continued)

SHoe Plate SIzeS

There are two shoe plates included with
this tool. The thin plate (1/4 inch) is for
use on 3/4 inch thick hardwood flooring.
The thick plate (5/16 inch) is for use on
1/2 inch thick hardwood flooring and
5/8 inch bamboo flooring.
To prevent damage
to the flooring, use
the correct shoe for the flooring being
installed. See Chart 1.
toolS requIred For CHaNgINg
SHoe PlateS
4 mm Hex Wrench (supplied)
u
Threadlock Glue
u

CHaNgINg SHoe PlateS

1. Disconnect the air supply from nailer.
2. Using provided 4 mm wrench, remove
the three shoe screws (see Figure 11).
3. Remove shoe plate; place new or
alternate shoe. Make sure shoe is in
the "UP" position when attaching.
4. Reattach screws, applying a good
quantity of threadlock glue on screw
threads before installing. Tighten
firmly.

Set-Up

lubrICatIoN

This nailer requires lubrication before
using the nailer for the first time and
before each use. If an inline oiler is used,
manual lubrication through the air inlet is
NOT required on a daily basis.
The work surface
can become damaged
by excessive lubrication. Proper lubrication is
the owner's responsibility. Failure to lubricate
the nailer properly will dramatically shorten
the life of the nailer and void your warranty.
1. Disconnect the air supply from nailer.
2. Turn the nailer so the air inlet is facing
up. Place 4-5 drops of 30 W non-
detergent oil into air inlet (see Figure
12). Do NOT use detergent oils, oil
additives, or air tool oils which contain
solvents. This will damage the nailer's
internal components.
10
www.chpower.com
Chart 1
Figure 11 - uP position of shoe plate
Figure 12 - tip nailer to add oil
WHAT PLATE IS USED FOR THE 5/8" BAMBOO FLOORING?
Plate Thickness
1/4 inch
5/16 inch
Shoe Plate Screws
4 mm wrench
Flooring Thickness
3/4 inch
1/2 inch and 5/8 inch
UP position
Oil Here