Hkoenig V34 Manual De Instrucciones página 7

Central vapor
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 31
CLEAN THE BOILER AT REGULAR INTERVALS
Release the residual steam in the boiler when you use up. Cut down the power, after the appliance
refrigeration enough put up one side of the cleaning valve(10), turn the cleaning valve(10)(do not lie
flat the appliance when you open the cleaning valve, otherwise the water will leakage).Then fill
appropriate water into boiler, insert the boiler cleaning brush and turn the cleaning brush to clean
the boiler, then waggle the equipment softly and pour-out the water. Repetition clean 2-3 times, then
assemble the cleaning valve back and screw it tightly.
SUGGESTIONS
- Divide the washing according to the correct ironing temperatures. Start by ironing those garments
that require a lower temperature. For fuller details, refer to the chart at end of this booklet.
- Fabrics such as velvet and wool, and accessories such as gloves, handbags, etc. will regain their
brand-new look and texture by simply passing the iron near the surface of the fabric and pressing the
steam button.
- Imprints left in carpets by furniture can be removed by applying steam on the parts where the pile
is crushed and the brushing lightly.
If the carpet is made of synthetic material, do not select a high temperature.
How to get a professional ironing finish
A normal iron generates only a small quantity of steam. In this case it is necessary to products steam
constantly in order to eliminate crease in the fabric being ironed.
A professional ironing system works rather differently. The fabric is first made damp by the steam and
then, in a second phase, dry-ironed in the normal way. This means that every. Tiniest crease is removed
and your garments are ironed to perfection.
In the first phase (steam-damping of the fabric),hold the iron about 20 cm above the fabric and press
the steam(2). Pass the iron over the garment in a circular movement so that the powerful jet of steam
damps the fabric. Lightly creased garments require only a few moments of steaming. While very heavy
fabrics or garments with particularly difficult creases must be damper, so steam must be applied for a
few seconds more.
During the second phase (dry ironing), check that the thermostat knob is in the correct position for the
type of fabrics; release the steam button(2) and dry-iron the garment. The special ironing plate will
prevent the fabrics from becoming shiny. Using this ironing technique, and following the suggestions in
the chart below, you will find it easy to give your garments a really professional ironing finish.

Publicidad

Tabla de contenido
loading

Tabla de contenido