Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALL ELECTRICAL
WARNING : Electrical wiring must
be done by a qualified person(s) in ac-
cordance with all applicable codes and
standards. This range hood must be prop-
erly grounded. Turn off electrical power at
service entrance before wiring.
1. Run 2-wire-plus-ground 120 VAC power
cable to downrod mounting bracket.
2. Remove (2) screws from wiring box cover
and remove cover. Fig 11.
3. Remove 7/8" diameter knockout from
end of wiring box.
4. Run range hood wires from downrod
through grommet and into wiring box.
5. Run 120 VAC power cable into opposite
side of wiring box. Secure cable to box
with an appropriate cable clamp.
6. Make wire connections using appropri-
ately sized wire connectors. Connect
white-to-white, black-to-black and green-to
ground.
7. Push wiring inside wiring box.
8. Replace wiring box cover and fasten
with (2) screws. Make sure wires are not
pinched.
9. Slide decorative ceiling cover up until
holes align with (2) holes in downrod
mounting bracket. Fig. 12.
10. Replace & tighten (2) screws.
120 VAC POWER CABLE
GROMMET
RANGE
HOOD
WIRES
(from
downrod)
- 9 -
WIRING
BOX
GREEN TO GROUND
BLACK
TO
BLACK
WHITE
WIRING BOX
WHITE
COVER
FIG. 11
FIG. 12
TO
Publicidad
Tabla de contenido
