Assembly; The Stand - Evolution RAGE5-S Instrucciones Originales

ASSEMBLY

To assemble this saw you will need: Cross head screwdriver, 8mm & 10mm spanner or socket
wrench, 13mm Socket wrench, 5mm allen key and a rubber mallet.
Note: This process can be considerably aided by studying the images of the assembled machine
and the components found on the machine overview & what's in the box pages. Unpack all
components including fixings and familiarise yourself with them before attempting to assemble
the machine. Enlist competent help when assembling this machine. Use the rubber mallet to aid
assembly.
THE BUILD PROCESS:
WARNING: This machine is heavy. Enlist competent help when moving or lifting this machine.
Step 1
• Align the table extension with the end of the rear slide rail. (Fig. 1)
• Adjust the front slide rail until the measuring indicator reads 0 on the ruler.
• Align the height of the table extension with the main table.
• Tighten the 4 screws located on the under side of the table extension.
Step 2
• Invert the main body of the machine and place on a clean, secure and sturdy workbench or
similar (Fig. 2).
• Select the two components labelled 1.
• Attach the two components to the machines main body using fixings B, I and L (Fig. 3).
• Select the two end caps labelled O and push them into the angled ends of the components.
• Select two end caps labelled N and push them into the straight ends of the components.
Step 3
• Select the components labelled 2 and 3. Attach 2 to 3 using the fixings C and M (Fig. 4) .
Step 4
• Select the components labelled 3 and 4.
• Attach component 4 to 3 using the fixings labelled A, J and K. Do not over tighten. Repeat on
the other side. (Fig. 5). Note the position of the spacers J which are required to provide the
necessary clearance for the frame to operate.
• Ensure that component 4 is the right way round and that the latch on component 3 engages the
latching pin on component 4 correctly (Fig. 6).
• Select two end caps labelled N and push them into the ends of component 3.
Step 5
• Attach component 4 in its service position on the machine. See that the position of the latching
lever and pin is on the same side as the rise and fall/bevel adjustment hand wheel. (Fig.7) .
• Use fixings labelled A, J and K ensuring that the spacer J is correctly positioned to provide the
necessary clearance for the frame to operate. Do not overtighten.
• Repeat on the other side. (Fig. 8).
Step 6
• Select the components labelled 5 and 6. Attach component 5 to 6 using the fixings labelled D
and M (Fig. 9).
• Select the remaining two end caps labelled N and push them into the straight ends of
component 6.
Step 7
• Attach component 3 to the rest of the leg assembly using the remaining fixings labelled
A, J and K (Fig. 10). It may help to move component 4 out of the way.
• Manoeuvre component 3 and 6 so the bolt holes line up. (Fig. 11).
Step 8
• Attach the wheels 7 to their service position on component 3 using fixings P (Fig. 12). Do not
over tighten the wheels, as this will prevent them from moving freely.
• Enlist competent help in turning the table saw over. The stand assembly is now complete.
www.evolutionpowertools.com
16