Items Supplied; Assembly - Evolution RAGE 5 Instrucciones Originales

www.evolutionpowertools.com
and the importance of local extraction (capture
or source) and the proper adjustment hoods/
baffles/chutes.
k) Use proper extension cord. Make sure any
extension cord is in good condition. When using
an extension cord, be sure to use one heavy
enough to carry the current your machine will
draw. An undersized cord will cause a drop
in line voltage resulting in loss of power and
possible overheating.
l) Always use safety glasses. Also use a face
or dust mask if the cutting operation is dusty.
Everyday eyeglasses only have impact resistant
lenses, they are NOT safety glasses.
m) Maintain tools with care. Keep tools sharp
and clean for best and safest performance.
Follow instructions for lubricating and changing
accessories.
n) Disconnect from the power supply before
servicing, cleaning or and when changing
accessories, such as blades.
o) Use recommended accessories. Only use
genuine Evolution accessories.
p) Check for damaged parts. Before further
use of the tool, a guard or other part that
is damaged should be carefully checked to
determine that it will operate properly and
perform its intended function - check for
alignment of moving parts, binding of moving
parts, breakage of parts, mounting, and any
other conditions that may affect its operation.
A guard or other part that is damaged should
be properly repaired or replaced.
q) Keep hands out of the path of the saw
blade.
r) Never reach around the saw blade.
s) Turn off machine and wait for saw
blade to stop before making any fence
adjustments.
t) Never pull or carry the tool by the power
cord. Carrying or pulling the tool by the power
cord could cause damage to the insulation or
the wire connections resulting in the possibility
of electric shock or fire.
u) When transporting the machine use a
transportation device.
Never use the guards for handling or
transportation.
v) During transportation the upper part of
the saw blade must be lowered fully and
covered by the guard.
w) All operators using this machine must
read the instructions and familiarize
themselves with the machines workings.
x) Never leave the saw running and
unattended. Do not leave the saw until the
saw has been switched OFF, and the blade
has come to a complete halt.

ITEMS SUPPLIED

Description
Blade Changing Tools
Mitre Gauge

Assembly

Hold Down Clamp
Assembly
Adjustable Rip Fence
Push Stick
Blade Guard
Instruction Manual
TCT Multi Purpose
Blade (Fitted)
Riving Knife
9
Quantity
3
1
1
2
1
1
1
1
1
EN
DE
ES
FR
IT
NL