Electrical Connection; Installing The Control Panel - Palazzetti MULTIFIRE BIO 9-14 Manual De Instalación, Uso Y Mantenimiento

6 INSTALLATION
in compliance with EN 10683.
6.1 LEVELLING THE STOVE
The stove must be levelled by adjusting the feet
(where featured), then checked using a spirit level
(Fig. 6.1).
6.2 SYSTEM CONNECTIONS

6.2.1 Electrical connection

The stove is connected to the electrical system
simply using the plug supplied.
The electrical connection (plug) must be easily
accessible when the stove is installed.
If the power cord is damaged it must be replaced
to prevent any kind of risk.
6.2.1.1 Earth
residual current circuit-breaker in accordance with
legislation in force (Fig. 6.2).

6.2.2 Installing the control panel

The stove's control panel can be mounted into a
plasterboard wall by cutting a hole (105x60mm)
Do not install the panel in a hot area of the hood.
Run the cable between the panel and the stove in
such a way that it is not damaged by heat when the
stove is running.
The control panel hooks up with its cable to
connector RJ11.
INSTALLATION
Fig. 6.1
Fig. 6.2
39