Palazzetti MULTIFIRE BIO 9-14 Manual De Instalación, Uso Y Mantenimiento página 54

11.2 RESETTING ALARMS
After having checked the type of message, the alarm can be reset by pressing the on/off button
moments.
11.2.1 Special cases (Technical Service Centre only):
E 1 0 8
Error " "
If the error code is "
its cap and pressing the reset button.
Reset the alarm by holding down the on/off button for a few seconds
You can now start up the stove again.
E 1 0 4
Error " "
If the error code is "
Remove any foreign bodies inside the brazier.
If this is not possible, run the manual mechanical brazier cleaning procedure:
a) Use the arrow keys
b) Enter the password "7" with key
c) Select submenu
d) Enter password "54"
e) Hold down key
the brazier door closed.
Reset the alarm by holding down the on/off button for a few seconds
Wait a few minutes, then start up the stove again.
Only do this when the stove is off and completely cold.
54
USE AND & MAINTENANCE
E 1 0 8
", it may be necessary to re-arm the manual reset thermostat (Fig. 11.1-A) by unscrewing
E 1 0 4
" proceed as follows:
to enter the setup menu
[ 3 2 ]
to start the manual loading system.
.
and press key ;
;
;
.
for a few
B
A
Fig. 11.1