Genius Car Alarm
Genius Car Alarms
Shock sensor – Dual zone
The shock sensor is designed to detect strong shock on the vehicle (collision), impacts,
movements trailer, breaking windows. It can also be triggered by the shock waves produced
by noisy exhausts, by thunder or heavy traffic. The shock sensor will NOT be powered by
wind or oscillating movements. When the sensor detects slight shock impact, the siren will 5
sounds and lights give 2 flashes. If the sensor detects an impact heavy blow, the siren will
sound and lights will flash for 60 seconds.
The level of sensitivity will be set by the installer and should be in optimal sensitivity Excessive
sensitivity can cause false alarms.
Ignition Anti-hijacking
This function is in software memory to activate the anti-hijacking automatically whenever the
ignition swiche the OFF position to the ON position without opening a door or pressing the remote
control button. Passing the swiche ignition to the ON position the LED on the board start flashing,
the vehicle lights give 2 flashes, if the acoustic signal is programmed, the siren sounds 2 beeps,
This feature is programmable (see program table )
Door Anti-hijacking.
With the ignition ON, you open and close a door, the LED on the board start flashing, the vehicle
lights give 2 flashes, if the acoustic signal is programmed, the siren sounds 2 beeps, This feature is
programmable (see program table )
Activated Anti-hijacking
As soon as the alarm system from going to anti-hijacking cars lights give 2 flashes, if function 13 is
activated, the siren sounds 2 beeps, LED will start flashing slowly, after 30 seconds the lights begin
to flash and siren to sound intermittently after 15 seconds and the function 14 is programmed, the
cut ignition is activated intermittently producing an engine failure, after 15 seconds will activate the
ignition cut constant turning off the vehicle engine and closing the locks, the siren starts to sound
constantly.Deshabilitacion /
Disarm Anti-hijacking
To Disable the anti-hijacking before it starts to run the siren tones or 6 before 60 seconds after
activated anti-hijacking, press and release the reset button 1 time.
To disable anti-hijacking after starting the siren tones or 6 after 60 seconds after activated, hold or
pass the ignition ON, press the reset button the number of times the security code (factory is 1) and
wait 3 seconds timeout confirmation that the code entered is correct
Electronic siren
Install the siren under the hood, should you place it in a protected place away from heat and water
damage, while driving through deep water or clearings may be splashed with water causing
damage to the siren, set at a position that water does not damage . If you wash your vehicle engine,
protect the siren with a plastic bag to prevent damage. Damage caused by water or heat are not
covered by warranty.
Flashes Lights
When the siren is sounding, vehicle lights will flash simultaneously. The lights also blink when
arming and disarming the alarm system.
Warnings flashing lights
This is a visual indicator of the status of the alarm system.
A) 1 Flash – Armed
B) 2 flashes - Disarms
C) 3 Flashes – 3 flashes - Trunk or Hood open when arming.
4 Flashes - To disarm the alarm indicates trigger.
D)
26
www.geniuscaralarm.com
4
www.alarmasgenius.com