Publicidad
Idiomas disponibles
Idiomas disponibles
Genius Car Alarm
Genius Car Alarms
Panic function (Remote Control Genius)
With the alarm system armed or disarmed, press buttons 1 and 2 on the remote control for 3
seconds, activate the panic mode, the siren sounds, the vehicle lights flashing. To deactivate press
and release the button 2 on the remote control.
Channel 2 - Open trunk electric (remote Genius)
In programming the alarm system a transmission channel which can be used to open the trunk of
the vehicle power using the remote control, press the 4 button on the remote control for 3 seconds
and release immediately opens the trunk is design, if the alarm system is armed, you will not need
to disarm the alarm system and then open the trunk, simply press the 4 button, the alarm system
will open the trunk and does a bypass shock sensor and push the trunk line ..
Remote Anti-Hijacking (Remote Control Genius)
This function is used to hold the vehicle in an emergency by pressing the 3 button on the remote
control for 3 seconds while the driver of the moving vehicle, vehicle lights give 2 flashes, the LED
will start flashing indicating the activation of the Anti hijacking, if audible warning siren is scheduled
give 1 beep. This feature is programmable (see table programming functions)
Anti-Hijacking Far Away (Optional transmitter Genius - rolling code)
This function is used to secure the vehicle in case of emergency, simply opening a door and
moving the transmitter about 15 mts presence of the vehicle, the engine is running. If the
transmitter is present within the vehicle, the alarm signal and recognize the anti-hijcking went into
passive mode.
PASSIVE MODE:
The anti-hijacking remain in passive mode when the alarm first receives the
transmitter signal presence, the engine switched on.
The anti-hijacking mode becomes active when any vehicle door is
opened with the engine running.
When moving the transmitter presence begins a countdown of 60 seconds to
activate the anti-hijacking.
After 60 seconds, the next 15 seconds will give 2 flashes lights, the LED will
start flashing rapidly, indicating the activation of the anti-hijacking (if the
warning sound is programmed, the siren will give 2 beeps / Function Number
Presence Optional
13 ) for the anti-hijacking presence work, you will need to purchase the
Transmitter 370MHz
presence Transmitter (optional) and program it into the system memory and
Rolling Code
enable the alarm function number 16 function table
NOTE:
If you forget or misplace her presence transmitter when the alarm goes off the vehicle, you must
make a single touch to swiche valet, in less than 60 seconds after the vehicle ignition. This touch
must do so every time you start the engine
Presence transmitter power ON.
Press and hold the transmitter button, the red LED on the transmitter will emit a flash after 3
seconds the LED on the transmitter will stay on for 2 seconds. Release the transmitter button. The
transmitter will send a signal to the receiver module (Central Unit) every 6 seconds. When the
internal battery of the transmitter is low, the LED transmitter began to give warnings by continuous
flashes. You must replace the transmitter battery.
Presence transmitter power OFF.
Press and hold the transmitter button, the red LED on the transmitter will turn off a flash and, after
3 seconds the LED on the transmitter will emit 5 flashes. Release the transmitter button. The
transmitter is turned off
www.geniuscaralarm.com
31
www.alarmasgenius.com
9
Publicidad
