Descargar Imprimir esta página

Genius TRF Serie Manual De Instrucciones página 36

Ocultar thumbs Ver también para TRF Serie:

Publicidad

Idiomas disponibles

Idiomas disponibles

Function 19 / Detecting OEM lights.
When programming function 19 ON, the alarm system can only be armed and disarmed by the
pulse of door locks together with the warning light emitted by the vehicle when it closes and locks
open with the original remote control OEM. Thin White cable input sensor must be connected to
the lights but NOT be attached with thick white cable blinker light alarm.
Function 20 / Anti hijack by door.
Each time a door is opened and closed, the anti- assault is activated.
Function 21. Factory Reset.
This function was created to place all the functions of the memory of the alarm to the state as it
was coming from factory.
Security Code (Pin Code)
(Security Code Factory is assigned 1)
You can disarm the alarm system and disable Anti - assault by Swiche of
Ignition and entering the security code via the reset button.
You can change the security code using the following procedure:
1. Pass the ignition Swiche position OFF to ON 3 times and the third set it off in a time of
no more than 7 seconds.
2. The siren will sound and lights remain on, the system PIN entry into programming code.
Press and release the reset button the number of times the new code you want to enter
between 1 and 9.
3. The siren confirmed with the same amount of sound the number of new PIN code and
close the program.
Please record and save the number of new security code as it will be required to disarm the alarm
system in case of emergency or to disable the anti - hijack.
36
14
Genius Car Alarm
Genius Car Alarms
www.geniuscaralarm.com
www.alarmasgenius.com

Publicidad

loading

Este manual también es adecuado para:

G-5504 cfOem g-5504