Burley Hitch Guide; Opening Your Trailer; Installing The Wheel Guards; Attaching The Wheels - Burley Bee Manual Del Usuario

Burley Hitch Guide:

1. Safety strap
2. Hitch
3. Flex connector
4. Retaining pin

Installing the Wheel Guards

1. Insert wheel guard bolts through frame tube.
Match holes in wheel guards to bolts. Tighten
securely with hex key (Figure 4).
2. Repeat for wheel guard on other side of
trailer.
Figure 4
1
3
2
4

Attaching the Wheels

1. Push in the rubber button on the outside of
the wheel hub (Figure 5).
2. Insert wheel axle into axle receiver, and then
release the button. Pull firmly on wheel to
confirm the axle is fully engaged. (Figure 6)
OWNER'S INSTRUCTION & SAFETY MANUAL

Opening Your Trailer

1. Raise front frame tube and rear frame tube from
inside the trailer (Figure 1) until they sit together on
the plastic saddles (Figure 2).
2. Lock bars together by pushing down on latches
(Figure 3).
Closing Your Trailer
1. Remove Wheels.
2. Under cover (Figure 3), lift left and right red latches to
release frame tubes.
3. Fold flat.
WARNING
Care must be taken when folding and unfolding to
prevent finger entrapment.
4.
Figure 5
Figure 2
4.
4.
4.
4.
Figure 6
BURLEY.COM
Figure 1
Plastic Saddles
Figure 3
Plastic Saddles
Plastic Saddles
Plastic Saddles
Plastic Saddles
3
ENG