DRAMINSKI GMM Manuel De Instrucciones página 42

The procedure of measuring the grain humid-
ity is following:
a) Turn on the power supply with the red
"ON/OFF" button.
The name of the device will be shown for a while
on the display and then the model and serial
number. The name of the last measured sample
will always appear afterwards, for example "rye".
b) The appropriate species of grain should be
chosen using "s" or "t" buttons.
c) Having chosen the name press "OK" button.
Under the name there will be the instruction
"PLEASE WAIT" displayed for a short time (dur-
ing this time the device measures the electrical
capacity of the empty chamber).
ATTENTION!
While the instruction "PLEASE WAIT" is dis-
played the measurement chamber should be
empty and clean, as well as while turning on
the power supply of the device. During this
40 CHAPTER 3 MEASUREMENT
time the measurement chamber should not
be touched. You should not put your hand
inside or put any objects in.
d) When the instruction "pour in seed" appears
you should put the measured seeds into meas-
urement chamber using the dosage tube.
Filling the measurement chamber using the
dosage tube.
The slider should be put into the dosage tube's
slot until its semicircular edge suits the external
edge of the tube.
Next put the seeds into the dosage tube until it is
entirely filled. The surface of the poured seeds
and the upper edge of the dosage tube should
be at the same level.
Not quite filling the dosage tube can cause a
reading error. Overfilling the dosage tube will
have a weaker influence on the reading.
ATTENTION!
You cannot press the seeds in the dosage
tube.