Factory Defaults - Altec Lansing M812 Guia Del Usuario

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

To set RF channels:

This option allows you to adjust RF channels on the M812 so that you

can eliminate interference from other wireless devices or other M812s

nearby that use the same channel. The channels available are:

AUTO

This is a factory preset where the M812

automatically seeks a channel that does not

have interference.

CH1, CH2, CH3

One of these channels may be manually selected

to eliminate interference.

1. Hold down the INPUT key on the side panel of the wireless speaker

for three seconds. MENU appears in the display.

2. Press the VOLUME +/– key to scroll to RF CHAN.

. Press INPUT to select RF CHAN.

4. Press the VOLUME +/– key to scroll through the possible values –

CH1, CH2, CH or AUTO.

5. Press INPUT to select one of the three channels or select AUTO.

Note: When you select a channel on the speaker, you have to select

the same channel on the transmitter to keep sync. To do this:

• Press and hold the STANDBY key on the base transmitter for three

seconds. The standby LED (on the left) will blink. The SYNC1 and

SYNC2 LEDs indicate the current channel:

• LED1 – CH1. (LED 2 is off)

• LED2 – CH2. (LED1 is off)

• LED1 and LED2 – CH. (Both LED 1 and LED2 are on)

• No LEDs – AUTO.

6. Press the STANDBY key to change the RF channel.

7. Press and hold STANDBY for seconds to save your changes.

To program another IR remote to work with the M812:

This function allows you to program a remote that might come with

another product such as a CD player. This allows you to control a CD

player or other AUX device from another room.

Note: This programming can be performed successfully on most, but

not all, IR remotes.

1. Hold down the INPUT key on the side panel of the wireless speaker

for three seconds. MENU appears in the display.

2. Press the VOLUME +/– key to scroll to IR PROG.

. Press INPUT to select IR PROG.

4. Press the VOLUME +/– key to scroll through the remote keys that

can be programmed –

5. Press INPUT to select one of the keys. The display will show START.

6. Point the auxiliary remote at the M812 and press the key you want

to record.

7. The display shows DONE when the operation is complete and

resumes the previous operation.

To set DEFAULT

This option allows you to reset options as necessary. LOCAL default

sets VOLUME, BASS and TREBLE to the factory defaults.

FACTORY restores all options to the factory settings. IR programming

and FM presets are also erased. The RF channel is set to AUTO and the

FM default goes to US.

1. Hold down the INPUT key on the side panel of the wireless speaker

for three seconds. MENU appears in the display.

2. Press the VOLUME +/– key to scroll to DEFAULT.

. Press INPUT to select DEFAULT.

and

4. Press the VOLUME +/– key to scroll through the defaults – FACTORY

or LOCAL. Local default resets Volume, Bass and Treble settings, but

does not affect settings such as FM Mode, recorded IR commands or

FM presets. Factory default resets all settings as shown below.

5. Press INPUT to select one of the options.