Campbell Hausfeld PS2 A Serie Manual Del Usuario

Assembly Instructions and Parts List
Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described.
Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or prop-
erty damage! Retain instructions for future reference.
BUILT TO LAST
Assembly Instructions
LIGHT DUTY CART MODELS
Tools required: 7/16" Wrench or
adjustable
11/16" Wrench or
adjustable
Hammer
1. Open packaging and check contents
against packing list on hardware pack.
2. Stand pump upright and hold steady.
Attach axle to cart legs by inserting
pre-assembled bolts into holes in cart
legs. Secure with one 1/4" - 20 nut on
each bolt. Use 7/16" wrench to tight-
en (See Figure 1).
Figure 1 - Attach Axle
3. Slide one 5/8" I.D. washer and wheel
on to each end of the axle. Using a
hammer, tap a pal nut onto each end
of the axle to retain the wheels (See
Figure 2).
Figure 2 - Attach Wheels
4. Slide handle on to cart. Insert pre-
assembled bolts into holes. Secure
with one nut on each bolt. Use a
© 2005 Campbell Hausfeld
Airless Paint
Sprayers
Figure 3 - Attach Handle
wrench to tighten. Hose rack should
be facing the pump (See Figure 3).
5. Attach high pressure hose to pump
and spray gun using a 11/16" wrench
(See Figure 4). Do not attach suction
assembly at this time.
Figure 4 - Attach Hose
Assembly Instructions
HEAVY DUTY CART MODELS
1. Place washer from parts pack onto
axle.
2. Place wheel onto axle with side with
the longest hub going on first.
3. Place another washer on the axle.
4. Place cotter pin through hole in the
end of the axle.
5. Repeat for the other side (See
Figure 5).
For parts, product & service information
visit www.chpower.com
Airless Paint Sprayers
Figure 5 - Attach Wheels
6. Slide the two ends of the handle
over the two ends of the bottom
frame. The bend in the handle
should be away from the unit.
7. Stand behind the unit and reach
over the handle to grip the ends at
the bottom of the handle. Push
down on the handle (See Figure 6).
8. When the handle is all the way
down insert bolt into aligned holes,
then secure and tighten the nut
onto the bolt.
Figure 6 - Attach Handle
9. Place bucket hook over top of frame
with the hook to the outside of the
frame.
10. Line up the two holes in the bucket
hook with the two holes in the top
of the frame (See Figure 7).
IN421000AV 5/06