Worx WX254L Manual De Usario página 12

OPERATING INSTRUCTIONS
NotE: Before using the tool, read the
instruction book carefully.
BEForE oPEratiNG tHiS tool
a) CHarGE tHE BattEry
The battery charger supplied is only for the Li-Ion
battery installed in the machine. Do not use another
battery charger.
The Li-Ion battery is protected against deep
discharging. When the battery is empty, the machine
is switched off by means of a protective circuit: The
Chuck (6) no longer rotates.
When the battery is charged for the first time or after
prolonged storage, the battery will accept a 100%
charge after several charge and discharge cycles.
12
B) CHarGiNG (See Fig. a)
Plug the Charger into a suitable power outlet. Next,
connect the screwdriver to the Battery Charger at the
Charging Socket (9). The Indicator (8) will illuminate
Red during charging.
Let the battery charge for 5 hours. The battery is fully
charged as soon as the Indicator is no longer lit. Then
unplug the Charger. Disconnect the Charger from the
screwdriver. The screwdriver is ready to be used.
iMPortaNt:
When charging, the Charger and screwdriver may
become warm to the touch; this is normal and does
not indicate a problem.
2. oPEratiNG iNStruCtioNS
Inspect the screwdriver before using to ensure all
the parts are running smoothly and there are no
abnormal sounds or sparks. Before driving fasteners,
check behind walls for wires and other electrical
hazards or plumbing.
OPERATION
1. iNSErtiNG tHE Bit CartridGE (See Fig. B)
Pull the Cover (1) back completely to insert the Bit
Cartridge (7).
2. SElECtiNG a Bit
1. Slide the Cover fully open, past the red line
on the tool. The Bit Cartridge will advance
automatically. (The Bit Cartridge can be manually
rotated to left direction if preferred.)
Slide the cover forward completely to close
(See Fig. C1, C2).
2. Move the top Cover back and forth until the
desired bit is in place.
If the bits in the Bit Cartridge need to be replaced,
remove Bit Cartridge by pushing it up from the
window underneath. Replace the bits with the
desired bits. Ensure the bits are properly positioned
in the Cartridge and are not protruding from the back
of the Bit Cartridge.
Or, simply pull a bit from the holder, and replace it
with the desired bit. It will load into the Cartridge
automatically when the cover is opened (See Fig. D).
NotE:
1. Only 1" long, ¼" hex shank bits are compatible