Resetting To The Factory Default Settings; Further Information - Axis P85 Serie Guia De Instalacion

Page 14

Resetting to the Factory Default Settings

This will reset all parameters, including the IP address, to the Factory
Default settings:
1. Disconnect the network cable.
2. Remove the rubber cap from the control button hole.
3. Using an appropriate object such as a small screw driver, press and
hold the Control button and reconnect the network cable.
4. Keep the Control button pressed for at least 15 seconds.
5. Release the Control button.
6. Wait for at least 1 minute for the process to complete.
7. The camera has now been reset.
8. Re-assign the IP address, using one of the methods described in this
document.
It is also possible to reset parameters to the original factory default
settings via the web interface. For more information, please see the
online help or the user's manual.

Further information

Tip!
Visit www.axis.com/techsup to check if there is updated firmware
available for your network camera. To see the currently installed
firmware version, click the Basic Configuration menu item in the
product's web page.
AXIS P85 Network Camera Series