Install The Hardware - Axis P85 Serie Guia De Instalacion

AXIS P85 Network Camera Series

Install the hardware

Follow these instructions to attach the height indicator decal to the
pipe.
1. Find the lens hole by the 160/5ft marking on the decal and remove
the punch-out.
2. Carefully align the hole with the lens hole on the pipe and attach
the decal.
Follow these instructions to install the camera.
1. Attach the upper pipe to the lower pipe.
2. Place the pipe on the wall, with the lower end on the floor.
3. Attach the pipe to the
wall using the clamps.
4. Adjust the position of
the lens by rotating the
pipe.
5. Tighten the clamps to
secure the position of
the camera.
Note:
The lens is located in the
upper half of the pipe and is
at eye-level (160 cm, 5.3 ft).
Page 7
283 cm
(9.3 ft)