Intermediate Positions - SOMFY Universal Slim Receiver RTS Plug Guia De Instalacion

RTS Universal Slim Receiver - RTS Plug Universal Slim Receiver
5.3.2 Multiple control
Multiple control: an RTS Slim Receiver is controlled
by several RTS control points.
Caution: a maximum of 12 control points may be
programmed into an RTS Slim Receiver.
1) Press the PROG button on the programmed
control point (a) until the awning makes an up and
down movement: the RTS Slim Receiver will be in
programming mode for 2 minutes.
2) Briefly press the PROG button on the RTS control
point (b) to be added: the awning makes an up
and down movement; the RTS control point has
been added.
- Repeat these two steps to add each RTS control
point.

5.4 Intermediate positions

Two intermediate positions may be programmed: a
position accessible when the awning is raised, refer-
red to as intermediate position 1 (IP1) and a position
accessible when the awning is lowered, referred to
as intermediate position 2 (IP2).
5.4.1 Setting the intermediate position 1 (IP1)
1) Raise the awning to its upper end limit position.
2) Press the STOP/my button.
3) Press the Down and STOP/my buttons at the
same time: the awning is lowered.
4) Press the STOP/my button when the awning is at
the correct height.
5) If necessary, adjust the position of the awning
using the Up and Down buttons.
6) Press the STOP/my button until the awning makes
an up and down movement: intermediate position
1 (IP1) has been programmed.
5.4.2 Setting intermediate position 2 (IP2)
1) Lower the awning to the lower end limit.
2) Press the STOP/my button.
3) Press the Up and STOP/my buttons at the same
time: the awning is raised.
4) Press the STOP/my button when the awning is at
the correct height.
5) If necessary, adjust the position of the awning
using the Up and Down buttons.
6) Press the STOP/my button until the awning makes
an up and down movement: intermediate position
2 (IP2) has been programmed.
5.4.3 Using intermediate positions
- Press the STOP/my button to find the program-
med intermediate position (IP1 or IP2): the awning
starts to move and stops in the intermediate
position.
44
U_S_R_5054294X00_livre.indb 44
1 2
PROG. PROG.
a b
1 2
3 4
5 6
1 2
3 4
5 6
Copyright © 2007 Somfy SAS. All rights reserved.
Installation guide
2 min.
IP1
IP2
20/05/08 11:17:01