Starting Up The Appliance - Ghibli & Wirbel POWER EXTRA 11 Uso Y Mantenimiento

www.ghibliwirbel.com
Professional Cleaning Machines Since 1968
USING THE APPLICANCE
- The device is equipped with wheels and
then during use can be pushed by the
handle (21 Fig. 14).
- To lift it up insert your fingers under the
dedicated handle (22 Fig. 14) on the top
of the cover of the single version motor or
lift with the help of two people using the
handles (22a Fig. 14)

Starting up the appliance

- Insert the plug (23 Fig. 15) into the electri-
cal socket.
- For extraction washing, press the switch
(24 Fig. 16) on "I" to start the detergent
pump; the switch lights up.
Single motor
- Push the switch (25 Fig. 16) on "I" to start
the suction motor; the switch lights up.
Double motor
- Depending on the power required it is
possible to start only one motor by press-
ing the switch (25 Fig. 16) on "I" or both
switches (25 and 25a Fig. 16) if a greater
suction force is required.
When the switch pressed the correspond-
ing button lights up.
NOTE:
The suction motor and the detergent pump
operate independently; therefore, it is pos-
sible to:
- wash fabrics or floors/ carpets by starting
only the detergent pump;
- wash and suction liquid simultaneously
by starting up the detergent pump and
suction motor at the same time;
- suction liquids by only starting the suction
motor.
Washing floors or carpets
- For washing floors or carpeting is neces-
sary to fit the rigid tube (8-9 Fig. 17) and
the mouth floor (10 Fig. 17), if present.
- Put the nozzle (10 Fig. 17) perpendicular
to the floor / carpet (see Figure 17).
- Start the suction motor and the detergent
pump by pressing the relative switches
(24 - 25 - 25a Fig. 16).
- Press the lever (26 Fig. 17) to deliver the
cleaner, release to stop dispensing.
- The detergent released washes the floor/
carpet / and the dirty liquid is suctioned
into the tank of the appliance.
For very dirty areas it is recommended
you apply detergent to the dirty area with-
out suctioning it; leave the detergent al-
lowing it to work for several seconds and
then wash the area and suction the dirt.
NOTE:
To prevent the detergent pump from break-
ing, it is recommended that you stop its op-
eration, pushing the relative switch, when
dosing has not occurred for several minutes.
NOTE:
When the recovery tank is full, noise in-
creases and the appliance does not suction;
therefore, switch it off and empty the tank as
described in the relevant paragraphs.
Cleaning chairs
- Start the suction motor and the detergent
pump by pressing the relative switches
(24 - 25 - 25a Fig. 16).
- Place the mouthpiece on the fabric and
press lightly ; than press the lever (27 Fig.
18) to deliver the cleaner, release to stop
dispensing.
- For very dirty areas it is recommended
you apply detergent to the dirty area with-
out suctioning it; leave the detergent al-
lowing it to work for several seconds and
then wash the area and suction the dirt.
EN - 3