Cleaning And Maintenance; Daily Cleaning - Ghibli & Wirbel POWER EXTRA 11 Uso Y Mantenimiento

NOTE:
To prevent the detergent pump from break-
ing, it is recommended that you stop its op-
eration, pushing the relative switch, when
dosing has not occurred for several minutes.
NOTE:
When the recovery tank is full, noise in-
creases and the appliance does not suction;
therefore, switch it off and empty the tank as
described in the relevant paragraphs
Switching off the appliance
- Press the switches (24 - 25 - 25a Fig.
16) to "0" to switch off the appliance; the
lamps on the switches will go out.
- Remove the plug (23 Fig. 15) from the
electrical socket.
CLEANING AND
MAINTENANCE
DANGER:
Before performing any maintenance op-
erations, unplug the appliance from the
electrical socket.

Daily cleaning

Emptying the recovery tank
- Position yourself over a floor drain with
the appliance.
- Detach the drain hose (28 Fig. 19) from
its relative support.
- Unscrew the knob (29 Fig. 19) and re-
move the cap (30 Fig. 19) of the water
drain hose (28 Fig. 19) and empty the liq-
uid into the recovery tank (31 Fig. 19).
Cleaning the detergent dosing circuit
At the end of each workday, clean the de-
tergent dosing circuit as follows to prevent
clogging:
- Release pressure from the circuit by
pressing, with dosing pump off, the lever
(27 Fig. 18) or lever (26 Fig. 17).
- Disconnect the suction pipe detergent (6
Fig. 4).
- Release the levers (32 Fig. 20) and re-
move the complete cylinder head (7 Fig.
20) of the recovery tank (31 Fig. 20).
- Tilt the tank (7a Fig. 21) to discharge the
detergent in a container.
- Wash the inside of the detergent contain-
er with running water.
- Reassemble all of the parts performing
these operations in the reverse order.
- Pour clean water into the detergent con-
tainer, electrically connect the appliance
and start the dosing pump by pressing
the switch (24 Fig. 16).
- Clean the circuit by pressing the lever (27
Fig. 18) or (26 Fig. 17), depending on the
type of mouthpiece.
- Dispense the liquid from the nozzle until
clean water comes out.
- Empty the water in the detergent tank as
described above.
Cleaning the appliance body
- Clean the unit body with a cloth damp-
ened with water or a mild detergent.
- Remove the cover as indicated previous-
ly and clean the inside of the tank with
running water, leaving the drain hose
open (28 Fig. 19) then reassemble eve-
rything proceeding in reverse order.
DANGER:
Do not wash the appliance using jets of
water.
EN - 4
www.ghibliwirbel.com
Professional Cleaning Machines Since 1968