Product Operation; Powering The Revive On; Operating Modes - brondell REVIVE PR50-W El Manual Del Propietario

PRODUCT OPERATION

POWERING THE REVIVE ON

1. To power the Revive on, press the Power Button. The Operating Mode
and Fan Speed setting will automatically resume with the settings from
when the unit was previously powered on.
NOTE: If the Revive was previously in Auto Mode, it will begin sensing
the air quality in the room when powered on. During this time,
the Fan Speed will be set to 2, and the Air Quality Indicator will
show Violet. After 10 seconds, the Revive will adjust the fan
speed and Air Quality Indicator according to the air quality in
the room.
2. Also, when the Revive is powered on, the Humidity Indicator turns on
after a period of five seconds, reflecting the humidity level in the room.
Dry = 40% humidity or less
Moderate = 40– 60% humidity
Humid = 60% humidity or more
NOTE: During the five-second waiting period, the Humidity Indicator
lights will flash in sequence from Dry to Humid

OPERATING MODES

1. Once the Revive has powered on and performed the air quality and
humidity auto-sensing, you are free to choose between the four
different Operating Modes:
Auto Mode
During Auto Mode, the Revive checks the air quality in the room every
10 seconds and adjusts the Fan Speed accordingly. The Air Quality
Indicator will also change depending on the air quality:
Blue = Good air. Violet = Fair air. Red = Poor air.
Eco Mode
In Eco Mode, the Revive will run on Fan Speed 2 for ten minutes, and
then power the fan off for thirty minutes. This cycle will alternate until
you change to a new Operating Mode.
16
Step 1
Step 2