Installation - MANOSTAT CARTER 74-083-00000 Manual De Operación

INSTALLATION

Mount the Pump Head to the Pump Drive as follows:
1. Install the plastic Boot over the tang at the end of pump shaft, (Figure 1). This Boot prevents metal-to-metal
contact, and thus reduces noise. This Boot should be inspected and replaced when worn or at 500 hour intervals.
CAUTION: Not using the boot will damage the pump.
2. Connect the Pump to Drive by aligning the tang on Pump Head, (including installed boot) with the slot in the motor
Drive shaft.
3. Attach Pump Head to drive unit with four screws.
WARNING: Tubing breakage may result in fluid being sprayed from pump. Use appropriate measures to
protect operator and equipment.
Figure 1 PUMP MOUNTING
Figure 2 PLASTIC BOOT A-3480
5