Storage And Maintenance - Sweiss SKYVIEW 610 Manual De Instrucciones

3.STORAGE AND MAINTENANCE

When not in use,the lter should be stored in a dry place within the temperature
range of -20°C to +70°C Prolonged exposure at temperature above 45°C ma y
decrease the battery lifetime of the lter.It is recommended to keep the solar cel l s
of the f i lter in the dark or not exposed to light during storage in order to maintain
power down mode.This can be achieved by simply placing the lter face down on
the storage shelf.
Protection cover Lens ,both internal and external (Polycarbonate)
must be used in conjunction with the autodarkening lter in order
to protect it against permanent damage.
It is always necessary to keep the solar cells and the light sensors of the lter free of
dust and spatters:cleaning can be done with a soft tissue or a cloth soaked in mild
detergent (or alcohol).Never use aggressive solvents such as acetone.
If protection screens are in any way damaged,they must be immediately replaced.
- Replacing External Cover Lens : Remove lter holder by moving locks toward
center (Fig.1) and lift up the lter holder to remove/replace the external cover lens.
Replacing Internal Cover Lens : Place your ngernail in recess below the cartridge of
view window and ex lens upwards until it releases from edges of the cartridge of
view window.
- Change the Shade Cartridge: Remove lter holder assembly from helmet shell (See
Fig.1). Then ex top end of the lter holder to allow lter cartridge to be removed
from the frame. Install new lter cartridge into frame(See Fig.2). Make sure that the
lter cartridge is inserted in lter holder correctly as shown and install lter holder
assembly into helmet shell.
Fig.1
2
Fig.2