Auto-Darkening Filter Functions; Selecting The Operating Mode; Selecting Delay Time; Ma X 1.0 Second-Longer - Sweiss SKYVIEW 610 Manual De Instrucciones

5. AUTO-DARKENING FILTER FUNCTIONS

5.1 Selecting the Operating Mode

For some lters, two modes of operation can be selected: welding or grinding. (See
Fig.3)
Grind Mode: shade function is turned o . In this mode the shade is xed in the light
state that allowing a clear view to grind a weld with the helmet providing face
protection. Used for metal grinding applications.
Grind mode is intended for Grinding not for welding. Before restarting
welding, the knob should be set back to the " Weld position"
Weld Mode-Used for most welding applications.In this mode the shade function is
turned on. When it optically senses a welding arc, please select a suitable shade
level,delay time and sensitivity as required.

5.2 Selecting Delay Time

The Delay Time knob will vary from dark to light time,it can be set at MAX (1.0
second) or MIN (0.1second) by using the in nitely dial knob.(See Fig.6)
MA X 1.0 second-Longer delay is for most welding applications, specially for high
amperage (current) applications.
MIN (0.1 s ec ond)-Shorter delay is for Spot welding applications
Longer delay can also be used for T IG Welding in order to prevent the lter
opening when the light path to the sensors is temporarily obstructed by a hand,
torch, etc.
Fig.6
4
Fig.7