Technical Specifications - SORHEA UNIRIS II 50 Manual De Instalación

SORHEA
7

TECHNICAL SPECIFICATIONS

UNIRIS II 50 NH
(No Heater)
UNIRIS II 50
Maximum indoor detection distance
Maximum outdoor detection distance
Detection mode
Number of beams
Detection mode
Response time of intrusion alarm
Intrusion alarm typical duration
Power supply electronics only
Power supply heating (optional)
Power consumption with 12V:
Tamper output
Intrusion output
Operating temperature with thermostat-
controlled heating
Protection index
Weight
Electromagnetic compatibility
Cell orientation
Integrated alignment tools
Exterior dimensions (en mm)
In compliance with European environmental directives, this product must not be
thrown away but recycled through an appropriate subsidiary.
• Transmitter only
• Receiver only
• Entire barrier
Pulsed infrared cell with four selectable frequencies
Simultaneous interruption of all beams
Adjustable from 50 ms to 700 ms
Interruption time of beams with a 4 second minimum
10V to 14V DC
10V to 14V AC / DC
Electronics
20 mA
25 mA
45 mA
NC - alarm off 30V DC 50 mA
NC - alarm off 30V DC 500 mA
-25° C / +55° C
Compliance with European standards (CE label)
Horizontal : +/- 90° - Vertical : +10° -15°
Optical sighting system, audio tone of incoming
- 18 -
30 6004 00
30 6004 01
125 m
50 m
(channels)
2
Heating
120 mA
120 mA
240 mA
IP 65
630 g
signal
UNIRIS II 50