Selecting The Tone; Setting The Tone Volume; Activating The Esiren; Getting Repair Service Or Technical Assistance - Federal Signal eSiren Instrucciones De Instalación Y Servicio

Installation and Maintenance Instructions

Selecting the Tone

The eSiren is factory‑set to the "A" tone. To select the "L" tone,
remove the jumper on the tone generator/amplifier board (Figure 5
on page 12).

Setting the Tone Volume

The volume of the eSiren is adjusted by tap selection on the tone
generator/amplifier board.
Tap wires are labeled and . Power‑tap terminals are labeled
1 2 P1
to . The SPL for each set of taps is shown in Table 1 on page 7
P5
and Table 2 on page 8.

Activating the eSiren

To activate the eSiren, apply the appropriate line voltage to the
horn power input terminals. The horn remains active as long as
line voltage is present.

Getting Repair Service or Technical Assistance

Products returned for repair require a Return Authorization form
from your local distributor or from Federal Signal. To obtain
repair service or technical assistance from Federal Signal, call
708‑534‑4756 or 877‑289‑3246. For instruction manuals and
information on related products, visit:
www.federalsignal‑indust.com
Model eSiren
14