Bradley SN2013/TT Manual De Instalación página 2

SN2013/TT, SN2033/TT
Read this entire installation manual to ensure proper installation. When finished
with the installation, file this manual with the owner or maintenance department.
Installation
Compliance and conformity to local codes and ordinances is the responsibility
of the installer.
Separate parts from packaging and make sure all parts are accounted for before
Packing List
•
discarding packaging material. If any parts are missing, do not begin installation
•
•
IS
T H
E • until you obtain the missing parts.
S ID
U P
Make sure that all water supply lines have been flushed and then completely
turned off before beginning installation. Debris in supply lines can cause valves
to malfunction.
Product warranties may be found under "Products" on our web site at
bradleycorp.com.
Supplies required for installation:
• 3/8" diameter bolts and floor/wall anchors to anchor washfountain pedestal to floor and wall
• 1/2" nominal copper tubing for hot and cold water supply lines
• Standard P-trap (trap included with "B" or "H" drain type and some optional equipment)
• 1-1/2" drain lines and fittings
• Pipe sealant
• 110 VAC power source and conduit box for 110/24 VAC hard-wired transformer (supplied)
• 18-gauge two-conductor lamp cord with female connectors
Supplies recommended for installation:
• 1-1/2" vent or tie pipe on types vented through washfountain column
• Caulk (may be applied between backsplash and bowl to avoid debris accumulation)
• Electrical cut-off switch to the unit . This feature prevents accidental water delivery during regular
maintenance and service .
2
IMPORTANT!
10/21/2014
Bradley • 215-1762 Rev. A; ECN 14-00-007
Installation