Maintenance Schedule - Toro 22606 Manual Del Operador

CAUTION
Do not place your hands on the ends of the log when
loading the log splitter. This is a very UNSAFE method
and could result in injury to your hands.
• Only use your hand to push the control lever forward
(towards the log). If the log moves before it is contacted by
the splitting wedge, do not touch it while the wedge is
moving. Release the control lever, then reposition the log.
• Operate the log splitter only when standing in the safe
operating zone by the control lever (Figure 13).
Maintenance

Maintenance Schedule

Daily - before each use
Initial 20 hours
Every 25 hours
Every 50 hours
Every 100 hours - after the initial oil
change
Every 100 hours
Every 200 hours
Every 500 hours
1. Control lever
7. Only one adult should stabilize the log and operate the
8. To stop the machine; refer to Stopping the Engine.
Check the engine oil level
Check the hydraulic fluid level
Grease the rail I-beam
Remove debris from the unit
Check for loose fasteners or damaged components
Change the engine oil
Check the hydraulic lines for leaks, loose fittings, kinked lines, loose mounting
supports, wear, weather, and chemical deterioration
Clean the air filter
Change the engine oil
Change the hydraulic fluid
Change the hydraulic filter
Change the air filter
Clean the fuel filter
Clean and adjust the spark plug
Change the spark plug
Lubricate the wheel bearings
11
Figure 13
control handle, to ensure full control over the log and the
splitting wedge.