Tabla de contenido
Publicidad
PRO.BOSE.COM
Connecting a Spreader Bar to a Loudspeaker Module
1.
Confirm the orientation and position of the spreader bar in relation to the array
plates based on your array design.
Note: The center attachment point is slightly off-center to account for the module
center of gravity position. To confirm the spreader bar is in the correct orientation,
ensure the product label of the spreader bar is on the same side as loudspeaker
input panel.
Install one array plate on one side of the module (see Connecting Array Plates to a
2.
Loudspeaker Module on page 14).
3.
Insert the spreader bar into your chosen attachment hole on the array plate (from
step 2) and secure in place using the included hardware as shown.
Note: The spreader bar will still be able to rotate after the fasteners are in place.
Use caution to avoid personal injury and damage to product.
Note: The included small spacers are used only with the long array plates. Place the
spacer in between the array plate and the spreader bar.
4.
Install the second array plate.
Note: Torque screws to 40.7 newton·meters (30 pound·feet).
* Make sure the plastic lining of the fender washer is facing the array plate.
Installation Guide • ArenaMatch RIgging Accessories
e
Fender washer*
Installation
M12 screw
English • 17
Publicidad
Tabla de contenido
