Yakima KingCobra Guia De Inicio Rapido página 3

Fold hoops down Fold hoops down.
Secure rear of mount
Attach SnapAround
to crossbar
Wheel Setting
Find your front wheel size.
dO NOT use MOuNT WITh Wheels uNdeR 20"
1032932K-3/15
• Place assembly onto
crossbar.
• Insert bolts from
below and tighten
oblong knobs.
If using mighty mounts, insert bolts from
above and tighten oblong knobs.
• Install the carriage bolt.
• Install the wheel strap with the red
button toward you.
(The strap may need to go on first
depending on the bike-to-bar fit.)
Adjust wheel
grip to fit your
wheel size.
Align the bolt to
the SnapAround or
MightyMount and insert
into the square hole.
ATTACH THE HEX KEY AND
TIGHTEN COMPLETELY.
With red levers
open, slide the
wheel grip until the
lever is just above
the appropriate
wheel number.
Align contours in knobs to craddle front hoop Align knobs to craddle front hoop in the open
position.
in the open position.
Lift the tab on the end cap while
pushing. Push until the tab goes
into the hole.
The lever will "SNAP" when fully closed and will
cover the chosen number.