Yakima KingCobra Guia De Inicio Rapido página 2

Install front wheel assembly to tray.
Open wheel hoops.
Install wheel assembly with tray onto crossbars.
Do you have round,
square or factory
crossbars?
IF ROUND, continue to:
for Factory crossbars,
use MIGHTYMOUNTS
(SEE BELOW).
MIGhTyMOuNT useRs:
Remove embedded nut in oblong
knob. Push hex bolt into top of
knob until fully seated.
MOUNT BIKE BACKWARDS!
IMPORTANT—
If your MightyMounts
use bar caps, metal
bar caps should
be applied to back
crossbar (front of bike
mount). Refer to this
diagram in place of
your MightyMount
instructions.
1032932K-2/15
• Insert the shorter bolts
into the holes on top of
base plate.
• Loosely attach washers,
lock washers, wing nuts.
If you have
SqUARE BARS,
loosen the tabs
by bending them
repeatedly.
If yOu hAve A
fAIRING:
Mount your bike
backwards.
Installing the bike
facing forward may
result in interference
with the fairing.
• Slide the end of the wheel tray onto the bolt heads.
• Move forward as far as possible.
• Back tray up 1/8" to prevent contact.
Remove the tabs
with scissors or
pliers.
POsITION
ANyWheRe ON
cROssbARs.
The front of the mount
can straddle the
The wheel tray can
attach to either
side of the opposite
tower.
Tighten
wing nuts
securely.
Attach 2 SnapArounds,
open to front, on the
crossbar.
MOuNT
tower.