Schlage Control BE467F Manual Del Usaurio página 3

Install the Lock
1
Install bolt and strike.
Caution: Use provided bolt!
1a Adjust bolt length, if necessary.
Measure the backset.
If the measurement is 2C\v" (70 mm), extend the bolt.
Twist the
faceplate.
1b If desired, change to the square-corner faceplate.
1. Use a flathead screwdriver to
pry the faceplate off.
1c Install the bolt into the door.
If the bolt does not remain retracted throughout installation,
locking and unlocking could be reversed, resulting in an
unsecured residence.
Backset
2C\," (60 mm)
OR
2C\v" (70 mm)
Make sure the button
pops into place.
2. Press the square-corner
faceplate into place.
CAUTION
Make sure the word
TOP faces up when
installing the bolt.
Actual Size (2)
1d Install the strike into the frame.
Install all the parts shown for maximum security.
L
Door Stop
Actual Size (2)
Reinforcement Screws: Actual Size (2)
2
Install the outside assembly.
If the bolt does not remain retracted throughout installation,
locking and unlocking could be reversed, resulting in an
unsecured residence.
2a Install the outside assembly on the outside of the door.
Clips hold the
assembly on the door.
3
Install the inside assembly.
If the cam is not in the correct position during installation, locking
and unlocking could be reversed, resulting in an unsecured
3a Make sure the cam on the inside assembly is in the correct
position.
Drill pilot holes
Z\," x 3" deep
2 places
CAUTION
Route the cable over
the deadbolt and
through the door.
Route the tailpiece
through the slot in the bolt.
CAUTION
residence.
3