Using The Component Jacks To Connect A Dvd Player Or Other Digital Equipment; Multi-Channel Receiver - Sanyo HT27546 Manual De Instrucciones

USING COMPONENT JACKS TO
CONNECT A DVD PLAYER OR OTHER
DIGITAL EQUIPMENT
The Component Video jacks will accept any video
content.
Switch off DTV and external equipment before connect-
ing cables. (Cables are not supplied.) Follow these steps
to easily connect your STB or DVD Player to this DTV:
1
Connect DVD Player or similar digital equipment's
Component Video Out to the DTV's Component
Video Input jacks.
2
Connect DVD Player or similar digital equipment's
Audio Out to the TV's Audio Input jacks.
3
Press POWER to turn on the TV, then turn on
external equipment.
4
Press INPUT to select Component2 to view the DVD
program.
IMPORTANT NOTE:
These jacks accept
only 480i (standard
intelaced) signals.
DVD PLAYER
(or similar
digital device
such as a
Satellite
Receiver.)
What you will need
for connections:
Component Video Cable – 1
Audio Cable – 1
I
Press the INPUT key after connecting the cables, to select the Com-
ponent2 input signal. There is NO need to tune to a blank channel.
I
" No Signal" will appear randomly on the screen when no signal is
detected at the VIDEO2 (Y, Pb, Pr) inputs.
DIGITAL AV CONNECTIONS
2
DTV
BACK
COMPONENT
1
JACKS
REMOTE CONTROL
4
CONNECTING DIGITAL AUDIO OUT
JACK TO A MULTI-CHANNEL
RECEIVER
®
Dolby Digital Audio provides 5.1 channels of surround
sound (five full-range channels [5] and one low-frequency
effect channel [.1]). A fiber optics cable is used to carry
the 5.1 surround sound (for low-noise signal transfer).
1
Using a Fiber Optics cable, connect the DTV's Digital
Audio Output to the Digital Audio Input of a Multi-
Channel Receiver. (Fiber optics cable is not supplied.)
2
Press POWER to turn on the DTV, then turn on exter-
nal equipment.
NOTES:
When making the connection, do not pinch or kink the fiber
optics cable.
Red light visible at the Digital Audio Output does not nec-
essarily indicate that Dolby
Digital audio is made up of light pulses that the human eye
cannot detect. Dolby
Digital Audio Output only when received as part of a Digital
signal.
1
OPTICAL
DIGITAL CABLE
What you will need for
connections:
Optical Cable – 1
IMPORTANT NOTE FOR MONITOR USE:
If you did not connect an antenna, you must run All
3
Channel Search twice before you can select the AV inputs.
I
Position your DTV at least 2 feet from stereo speakers. The magnets
in the speakers may affect the picture quality.
Need help?
Visit our Web site at
®
Digital 5.1 audio is available.
®
Digital 5.1 audio is available at the
MULTI-CHANNEL
RECEIVER
REMOTE CONTROL
www.sanyoctv.com
1-800-877-5032
or Call
BACK VIEW
OF DTV
2
9