Principle Parts; Preparing The Pool; Tools Needed For Installation - Hayward PHANTOM 6000 Guia Del Usuario

Principle Parts

Caution - Risk of Equipment Damage
Hose may be stored folded pipe-to-pipe. Only first 3-foot hose
section and sweep hose must be stored straight, not coiled.
A. Wing
B. Large Capacity Debris Bag with Float Closure
C. Cleaner Connector
D. Sweep Hose Connector
E. Sweep Hose Adjustment Knob
F. Cam Cap
G. Rigid Pressure Hose
H. Hose Float
I. Hose Pipe Coupling
J. Hose Swivel
K. Adjustable Wall Quick Connect
L. Sweep Hose
M. Wear Roller
N. Rigid Hose Pipe
O. Universal Wall Fitting
P. Top / Auto / Bottom Switch
Q. In-Line Filter
R. Hose Swivel Assembly
S. Hose Cleaner End Assembly
T. Hose Wall End Assembly
U. Setup Pressure Gauge
Rigid Pressure Hose Parts (G)
Wall Quick Connect
O
G
K
4
Front view Product
A
P
F
R e a rview Product
C
M
E
D
L
N I
Q T
J
S
C
L
H M
The Phantom cleaner should not be used to clean the
pool for spring start-up until the following steps
have been taken:
1 . Clear the pool of any objects that might interfere with the
c l e a n e r 's operat i o n .
2 . Check to see that the water is at the recommended level.
3 . Check the water chemistry. The water should be properly
B
balanced (ph level) and the pool free from algae.
N o t e : Algae can adversely affect the operation and
p e r formance of the cleaner.
4 . Clean or backwash the filtration system without the
Phantom cleaner in the pool.
Caution - Risk of Equipment Damage.
A lw ays disconnect the Phantom Cleaner and hoses form the
Universal Wall Fitting and remove from pool before backwashing
or cleaning the filtration system. Failure to do so can damage the
Booster Pump and Cleaner.
5 . Clean the filtration system pump's strainer basket
N o t e : After installing the Phantom cleaner, clean the
f i l t r ation system at regular intervals according to individual
pool conditions.
New Pool Construction
1 . Brush newly constructed pool surface and manually
vacuum new surface debris before installing the
Phantom.
Sand (dense debris)
Always empty the Phantom bag when sand
(or heavy debris) effects the cl e a n e r 's stability
Pools with excessive amounts of sand should be manually
vacuumed before installing the Phantom.
K
R
U
Use Only Genuine Hayward Replacement Parts.

Preparing the Pool

Dedicated Booster Pump Return Line
The cleaner is designed to connect to a 1-1/2 inch dedicat e d
return line that is at least 6 inches below the normal water level
with 1-1/2 inch female threads. If the dedicated return line has
3/4 inch female threads, you will need to purchase a 1-1/2 inch
NPTF x 3/4 inch NPTM adap t e r.

Tools Needed for Installation

• F l at blade screwdriver for adjusting the Regulator on the
Wall Quick Connect.
• R i gid Pressure Hose Measuring Tape
(included in Bag #1).
5