Kramp GOPART FGP455239GP Manual Del Usuario página 8

STEP 3: INSTALLING THE HOPPER
1. Lower the hopper over the mounting assembly, carefully line up the holes in
the bottom of the hopper with the spindle in the mounting plate of the axle.
2. Use the M6 x 40 hex bolt and Ø6 flat washer to attach the hopper to the
mounting assembly and secure with M6 lock nut.
3. Make sure the gear and pinion gear works smoothly. If not, adjust again until
UK
the gear and pinion gear swivel smoothly.
4. Tighten all the hardware on the shaft support plate and hopper.
5. Insert the R pin through the top of the spindle.
Install the hopper onto the frame
tube assembly by 6 pcs of Hex
Bolt M6X40, Big Flat Washer Ø6
and Lock Nut M6
8
R Pin Ø3
Insert the swivel
axle into the hopper
first.