Service; Before Calling Service; Product Data Rating Plate; Installer Checklist - Thermador VCIN60RP Instrucciones De Instalación

Service

Before Calling Service

Troubleshooting
See the Use and Care Guide for troubleshooting
information. Refer to the Warranty in the Use and Care
Guide. Please be prepared with the information printed on
your product data rating label when calling (see Figure 31).
To reach a service representative, see the contact
information at the back of the manual. Before calling,
please note the complete model and serial number printed
on your product data rating label (see Figure 31).
Product Data Rating Label
The data rating label shows the model and serial number. It
is located under the filter (see Figure 31).
Figure 31: Data Rating Label Plate
Installation Instructions
The data rating plate
shows the model and
serial number. Refer to the
data label on the
appliance when
requesting service.
The data rating label is
located on the frame
behind the filter. Remove
the filter to view it.

Installer Checklist

Final Check
Specified clearances maintained to cabinet surfaces.
Appliance is level.
All packaging material removed.
Proper ground connection.
Owner is aware of location of the main circuit
breaker.
INSTALLER: Write the model number and serial
number found on the Product Data Rating Label in
the
USE AND CARE GUIDE.
and the
GUIDE INSTALLATION MANUAL
owner of the appliance.
To Clean and Protect Exterior Surfaces
• The stainless steel surfaces may be cleaned by wiping
with a damp soapy cloth, rinsing with clear water and
drying with a soft cloth to avoid water marks. Any mild
glass cleaner will remove fingerprints and smears.
• To polish and protect stainless steel, apply a stainless
steel conditioner with a soft cloth. The Thermador
Stainless Steel Conditioner is available for purchase in
the online eShop (www.thermador-eshop.com). Order
part number 00576697.
• DO NOT allow deposits to remain for long periods of
time.
• DO NOT use ordinary steel wool or steel brushes.
Small bits of steel may adhere to the surface causing
rust.
• DO NOT allow salt solutions, disinfectants, bleaches or
cleaning compounds to remain in contact with stainless
steel for extended periods. Many of these compounds
contain chemicals which could prove harmful. Rinse
with water after exposure and wipe dry with a clean
cloth.
Leave the
USE AND CARE
with the
English | 20 |