Lenco HPW-400 Manual Del Usuario página 17

6
USE IN COMBINATION WITH A MOBILE PHONE
You may pair the HPW-400 with your telephone. After doing so,
when you're listening to the radio or TV and you receive an
incoming call, you may use the headset to answer the call and
have your telephone conversation via the headset fully hands-
free. At the end of the conversation, the device will switch back
to the radio or TV.
6.1
To pair the headset with the telephone:
Via NFC (Near Field Communication):
If your mobile phone is provided with the NFC
functionality (Near Field communication), you
may pair the headset with your phone as follows:
1.
switch on the NFC function of your mobile
phone
2.
switch on the headset
3.
hold the phone against the headset
according to the below figure
4.
the headset and phone will be paired after
several seconds.
function does not work with IOS devices.
Via the Bluetooth menu: (optional)
If your phone is not provided with NFC,
you may pair the headset with your phone as follows.
1.
switch on the base and headset and make sure they are connected
with each other (check this by briefly listening to the sound of your
radio or TV).
2.
remove the adaptor of the base from the wall socket.
3.
on the headset, press and hold the MIC/PAIR button for approx. 5
seconds until the blue status LED starts flashing rapidly
4.
switch on the Bluetooth function of your mobile phone and have the
phone search for available devices. After several seconds, the "Lenco
HPW-400" will be found. Confirmed the pairing of the device.
5.
switch off the Bluetooth function of your phone
6.
insert the power adaptor of the base back into the wall socket and
wait until the headset is reconnected with the base
NOTE: The NFC pairing
17