Brother PRHCK1 Manual De Instalación página 3

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
About the Compact
Frame
These frames will be used for embroidering logos
or patterns on small items.
Verifying the package
contents
Check that the following parts are included. If any
item is missing or damaged, contact your
authorized sales representative.
■ Contents of compact frame kit
1.
4.
Embroidery frame holder E
1
Frame 70: 41 mm (H) × 70 mm (W)
2
(1-5/8 inches (H) × 2-3/4 inches (W))
Frame 50: 50 mm (H) × 50 mm (W)
3
(2 inches (H) × 2 inches (W))
Frame 44: 38 mm (H) × 44 mm (W)
4
(1-1/2 inches (H) × 1-3/4 inches (W))
Vertical frame (Portrait Orientation):
33 mm (H) × 75 mm (W)
5
(1-5/16 inches (H) × 2-15/16 inches (W))
Screwdriver (large)
6
Installation Manual
7
* Install embroidery frame holder E in order to
attach the compact frame.
2.
5. 6.
Hooping the compact
frame
The procedure for using the compact frame 50 is
described below.
1 Loosen the screw on the outer frame.
3.
1 Screw
2 Place the fabric with right side up on top of
the outer frame.
7.
1 Screw heads
• Be sure to place the outer frame so that the
3 Press the inner frame into the outer frame.
• Be sure that there are no wrinkles in the
1/3
1
screw heads on the embroidery frame are
facing up.
fabric after it is secured in the embroidery
frame.
1